vCenter Appliance fsck failed

vmware

We have recently come across a problem with a VMWare vCenter Appliance where it was stuck in a repetitive boot loop and fsck failed error message.

After some investigation we found that all that was needed to fix this issue was to run the following command:

 e2fsck -y /dev/sda3  

It will then check for errors and fix them, once it has completed you should then reboot your vCenter Appliance and it should run through the boot sequence successfully.

COMMENTS

If you have any questions about this guide, please feel free to post a message below using our comments system.

Free Subscription!Subscribe to our site to receive updates via email!

Enter your email address below and click the Subscribe button to receive email notifications about new and exciting downloads available through our website at https://www.techygeekshome.com

You will also receive notifications about new technical guides, latest news and MSI installer downloads that are available through our blog here at https://blog.techygeekshome.info 

We will not spam you and we will not pass on any of your details to anyone else. We tend to post new content once or twice a week.

Join 232 other subscribers

You can unsubscribe any time you like.

About A.J. Armstrong

Founder of TechyGeeksHome and Head Editor for over eight years! IT expert in multiple areas for over 20 years. Sharing experience and knowledge whenever possible! Making IT Happen.

View all posts by A.J. Armstrong