Unattended Command Line Installation of DWG Trueview 2015

Table of Contents

Last updated on March 30th, 2023 at 06:38 pm

Read Time:1 Minute, 13 Second

To install Autodesk DWG Trueview 2015 as a unattended silent install, which you can also use in SCCM to add the application to the software catalog and also in WDS as an application install, you should first download the installation files that you require from the link below:

Download

DWG TrueView 2015 Download Link

Instructions

Once you have downloaded the executable file, you should extract the installation files from it. Then use the command line below from the root of the extracted setup files:

 setup.exe /w /t /l /q setup.ini

You can then also use the command line below for the uninstall string (change x86 for x64 where appropriate):

 msiexec /x "x86/dwgviewr/dwgviewr.msi" /q /norestart

You can then also use the MSI file located here for the detection method (change x86 for x64 where appropriate):

 x86/dwgviewr/dwgviewr.msi

A little tip as well is that the full version of Microsoft Dot Net 4 Framework is required for this install, if you do not have it installed, create this as an application as well and add it as a Dependency and it will install it for you as part of this installation. I’ve added another post on how to add Microsoft Dot Net Framework as an application in SCCM here.